11 replies to this topic

[Nudges]

Hello, could some one tell me if its possible to change the cost per play on stack attack and if so how or is 25p the only one it can be? Thanks

[spa]

I just sold a stack attack

I would say it will go to 30p without a problem. What key does it have in? Does it have switches on or just a block?

[Lewb]

switches i think

[Bencrest]

It should handle

£5 Jackpot - 5p/10p/20p/25p/30p and
£25 Jackpot - 25p/30p

Don't think they did a 50p chip for Stack Attack, they saved that for clones like Vortex.

[Lewb]

ok thanks so if i wanted £5 jackpot would i need to get another chip as its £25 atm

[PMK]

You need a stake/prize key. I had one of these and mine was set on 25p play and I wanted it on 30p. When you open the machine on the main board there are two square looking things at the bottom of the main CPU. One is %age the other is stake/jp value.

Get one from ebay(there only a few quid). Or try advance lesiure, the guy there is very helpful and could probably help you with your query and/or supply a stake key for you.

[Lewb]

okay thanks for your help

[Lewb]

Could some one tell me how you get all the money out of the hopper or is the only way taking the hopper box thing out your self? thanks

[skabaz]

turn machine on

open both cashbox doors

turn refil key when powered up

push little black button inside the inner cashbox door(for about 2 seconds)

machine will then dump the hopper when the start button is pressed

baz

[Lewb]

Thanks for the help. is there a way to change the hopper float back to £125 as its at £250 as it use to have a note acceptor but no longer does? Thanks

[DildoDez]

Thanks for the help. is there a way to change the hopper float back to £125 as its at £250 as it use to have a note acceptor but no longer does? Thanks

Not quite the answer you're looking for, but if u refill it with £125 coins, and press "hopper topped up" it will think that there is £250 in it, but act as a £125 hopper.

The real answer to your question is yes, but i don't know how.

[impact]

Check first as to what DildoDez said. If the float is still the same try looking @ Aux port and remove the loom plugged in while the machine is off first tho.. as there is a link wire to let the mpu5 know there is a note acceptor pluged in. Even if there is not one at the other end. To where it should be.