7 replies to this topic

[djmindoverload]

hi peeps im new here and need help.
i turned on my machine today and it died on me.
i open up the back and then turned it on again.
to see that only one led light on the board is lit up.
its the l9 led. and nothing else
ive checked the fuses and they seem fine.
i dont understand whats up because it was working fine before i went to bed.

can any one help me thx.

p.s dose anyone have the service manual for rhis machine.

Edited by djmindoverload, 29 April 2009 - 11:12 AM.

[lincs1]

hi peeps im new here and need help.
i turned on my machine today and it died on me.
i open up the back and then turned it on again.
to see that only one led light on the board is lit up.
for he voltage.
ive checked the fuses and they seem fine.
i dont understand whats up because it was working fine before i went to bed.

can any one help me thx.

p.s dose anyone have the service manual for rhis machine.

hi, i wouldn't say august 2008 as a new member likes, pmsl

but welcome to fruit emu

it maybe that your power supply unit has died of death as its a normal fault for maygay shite.

but before u replace the psu best check to make sure all connections are connected.

[djmindoverload]

i know the machine as been making a lot of noise.
like every time a lamp filcerd it would buzz.

i just noticed my battery is lookin a little worse for wear aswell.
i think im a strip the machine down this weekend clean it up an rebuild.
with some new parts

hopfully that will do the job.

[lincs1]

i know the machine as been making a lot of noise.
like every time a lamp filcerd it would buzz.

i just noticed my battery is lookin a little worse for wear aswell.
i think im a strip the machine down this weekend clean it up an rebuild.
with some new parts

hopfully that will do the job.

normally the buzz from the lamps is a strain on the psu which may have weaken a part within the psu namely the capacitor

[djmindoverload]

so i do need a new psu then.
any idea where i can get one.

[lincs1]

so i do need a new psu then.
any idea where i can get one.

ebay is your best friend

[djmindoverload]

ive been lookin on the inside of the machine and is the suposed to be loads of loose wires with conactors just doing nothing.

cus ive one lead just show bear prongs was thinking if that was to touch somthing metal things could get seriously messed up.

[lincs1]

ive been lookin on the inside of the machine and is the suposed to be loads of loose wires with conactors just doing nothing.

cus ive one lead just show bear prongs was thinking if that was to touch somthing metal things could get seriously messed up.

if your talking about the wires near to the meter's then don't worry unless u got a datapack fitted