Hi Folks,
Just wondered if anyone could shed some light on the error - MPU Error 9C. Its a DOND Dream Factory machine and this is the second board i've tried with it. Oddly the error seems to clear after 5 - 10 minutes and the machine plays fine.
Thanks
Scott.
5 replies to this topic
#2
Guest_barcrest junky_*
Guest_barcrest junky_*
-
- Guests
Posted 24 October 2012 - 07:37 PM
Cardie had that on a Scorp 4 machine he owned. Found the thread over @ Mecca, but doesn't say what happened with the error.
http://www.fruitemu....ng/page__st__20
bj
Brace yourself though before you click through the link - he has his own piccie as an avatar
http://www.fruitemu....ng/page__st__20
bj
Brace yourself though before you click through the link - he has his own piccie as an avatar
Edited by barcrest junky, 24 October 2012 - 07:38 PM.
#3
Starleisure
-
- New Members
-
- 265 posts
Junior Member
Posted 24 October 2012 - 07:40 PM
Hi,
The replacement board needs to have a track linked as its a non compliant scorp 4 board.
Off the top of my head i could not tell you the area/ tracks to link but the SC4 boards got updated so older boards throw up these issues.
Best wishes
Stu.
The replacement board needs to have a track linked as its a non compliant scorp 4 board.
Off the top of my head i could not tell you the area/ tracks to link but the SC4 boards got updated so older boards throw up these issues.
Best wishes
Stu.
#4
skabaz
-
- New Members
-
- 2778 posts
Engineer of the World
Posted 24 October 2012 - 08:26 PM
what star leisure said is correct.your dream factory machine needs a scorp 4 board with a wire link on the back of the board.check your original and it should have the link.
baz
baz
#5
Niven
-
- New Members
- 38 posts
Junior Member
Posted 24 October 2012 - 09:06 PM
That's great, thanks guys - I'll get on to it tomorrow and see what I can do 
#6
Starleisure
-
- New Members
-
- 265 posts
Junior Member
Posted 24 October 2012 - 09:18 PM
Your welcome - Im sure if yours is missing the link Baz may have spare he could sell you.
2 user(s) are reading this topic
0 members, 2 guests, 0 anonymous users
