12 replies to this topic

[banditboy2006]

to set the meters up can i use a setting from one all ready working to copy to the other that i am working on

[Guitar]

Use the small IO viewer. Tick the enable box and you'll be able to see the meters / triacs flash when its paying out or you are coining up.

[banditboy2006]

then what i flashes i need to set that on the switches below

[Guitar]

You need to set it up in the MPU4 Config Form, not the Small IO form.

[banditboy2006]

crystal maze is a no go for me as the lamp importer as only gone and missed about 130 odd lamps

 

it lit up around 20 from the orginal 159 eek and there aint that many lamps on amber to use

[Guitar]

crystal maze is a no go for me as the lamp importer as only gone and missed about 130 odd lamps

 

it lit up around 20 from the orginal 159 eek and there aint that many lamps on amber to use

 

Have you turned on the lamp extender in MPU 4 configuration?

[banditboy2006]

sorted it i was thinking straight not enough sleep

 

it will take me a while though as everything is all over the place

 

lamps allready lit but in the wrong place

[ploggy]

You can just copy the CHR numbers from MFME and add them to Amber.

[Guitar]

You can just copy the CHR numbers from MFME and add them to Amber.

 

You need to copy the last 8 numbers only.

[banditboy2006]

here is a chr for a machine that i am looking at here is a piccy

 

which one should i use

 

i know its the last 8 digits

 

 

and before you say anything i know its your layout vecs

Attached Files

•  d.png   893.1KB   1 downloads

[banditboy2006]

done that think still dont show they are even correct even as the lamps are the same as mmfe

 

the techinal side is done 

 

it just needs

 

the lamps sorting

Edited by banditboy2006, 10 April 2014 - 10:49 AM.