Best Answer Bencrest, 11 June 2014 - 06:12 PM
Right - I managed to fix the wonky box values today!
I decided to take the cover off the Scorpion 4 board just to make sure the obvious stuff was OK - and make sure there wasn't any battery damage e.t.c.
Decided to unplug the connectors on the Scorpion 4 board that run to the LED breakout board - and the bottom pin of the bottom LED output on the mainboard was bent at a right angle (not in the connector) - bad fitment when the previous operator presumably swapped a board over.
Bent the pin back into place, refitted connectors, fired up - and now the boxes display correctly!! Wish all jobs were that simple
So I've still got a duff(ish) PSU, but at least all the values are now correct. Will help if / when I come to sell it on
Worth anyone else with 'wonky' values checking the connectors on theirs too
Go to the full post