9 replies to this topic

[kirky]

Hello guys, I'm in need of a little help I've just acquired a ace pot of gold fruit machine for the kids, and could do with the settings for the %payout, also I need to know how to reset the coin float settings and stuff all help would be gratefully appreciated

[aaamusements]

Hello guys, I'm in need of a little help I've just acquired a ace pot of gold fruit machine for the kids, and could do with the settings for the %payout, also I need to know how to reset the coin float settings and stuff all help would be gratefully appreciated

 

Is the percentage on the machine set via a plug-in key or are there switches on the main board?

[kirky]

Hi there's a plug mounted on the left side with 8 switches on it and also one on the motherboard with 8 or so switches on

[aaamusements]

Try this on the plug-in key.

 

Take a photo of the original settings before you change anything, just in case!

 

 Lotelle Prize Stake Key Sticker.jpg   127.82KB   1 downloads

[kirky]

Thanks for that, does anybody know how to reset hopper levels or how do I put a float in it so it knows what money in it

[aaamusements]

Normally through using menus via a refill key with doors open, but I can't remember specifics for these.
What's the tech? I might have a generic manual.

Once you've done a hopper dump the machine will know where it is again and any new coins going in the hopper will be properly accounted for.

[kirky]

Not sure what tech is all I know is its jpm pot of gold

[TommyC]

Probs be impact.

[aaamusements]

What an odd coincidence... I did wonder why this machine was sticking in my mind.

A few days ago I was trying to tidy up a bit and was sorting through a box of old manuals that I keep meaning to get sold.

This machine manual was in amongst them!

[kirky]

I know most of the basics about them to be fair, its just I never owned one with 2 dil switches, I would like to be able to play about with the prize %.its currently set at 78% payout,, also would like to change stake and jackpot settings, I tried changing the setting using the chart on the above post but machine went into error mode,