46 replies to this topic

[pershorepcs]

worth a try I suppose but already used 2 different main boards so would think that would do similar

The only other thing i can suggest is to flick one of the 8 dip switches with the machine turned off. Power on, (you should hear a funny noise) then turn power off and put the dip switch back to where it was before. Power back on and see if that works.

[pershorepcs]

Right just found hd3 and hd4 not plugged into main board with another plug with 6 pin holes not plugged into anything that is linked to both of the plugs I found unplugged.. does anyone have any idea where that I supposed to go

[TommyC]

These are what should be plugged in from top to bottom.

 

Hd 1,2,7,8,9,10,11,12

 

Check Cn2 edge connector and check pin Z aka 22A and pin 22B See if there wired to the edge connector,these can brake easily and that could be causing your problem.

[pershorepcs]

Here is how my board is wired

Attached Files

•  IMG_0163.JPG   146.22KB   1 downloads

[chasnbons]

Not sure it yours is different (or should be) but this is how my Bar x 10 was wired

 

 HPIM1824.JPG   276.78KB   1 downloads

 

Sorry for bad pic but it's all I got mate and machine is long gone (big mistake cos I miss it)

[pershorepcs]

Ok on mine it is pin 2 to pin 9 pin 4 to pin 10 and pin 9b to 11.Thats the setting for the cashflow mech not mei.

just tried my plug same as yours and hey presto now diverting to cashbox when hopper full .. thanks for all the help

[TommyC]

Glad you got it sorted