4 replies to this topic

[mrjazon]

hi is there anyone out there who could help me im tryin to add a nv8 note acceptor to my machine it a mpu 5 barcrest (temple of treasure).

i need some kind member to point me in the direction where i can buy a front bezel for this acceptor(new or second hand)i found out that the loom goes to the aux on the mpu 5 but where can i get the loom and how do you remove the blank cover off the machine any help please guys or gals.

some one told me that the nv8 will not work on the mpu 5 can anybody verify this for me.

thanks in advance

jazon

[kensplace2]

Keep an eye on ebay.co.uk for note acceptor parts, they turn up from time to time, you should be able to get a bezel and maybe a lead from ebay if you keep looking long enough.

Failing that, you may need to buy a new lead, or make one up.

The blanking plate on the front of the machine is easy to remove, you first need to remove the whole payout tray, just open the machine's top door, and you will see three wingnuts near the reels. Undo those, and the payout tray will come off (be careful it does not drop of!). Put the tray to one side, then you should be able to finish removing the note acceptor blanking plate (there should also be a metal plate behind the plastic one, that needs removing also, unbolt if required, open lower door for access if needed)

Not sure about nv8 compatibility, got a JCM in my machine, so not looked into the smiley ones much, but you will need to make sure its the right interface, some acceptors are switchable between serial and parallel.

[mrjazon]

can anyone help me make a note acceptor loom got both end plugs just need to join the wires together.

its an nv4 going to a mpu5 barcrest

thanx again

[skabaz]

thanks for that

baz

[FruitBash]

thanks for that

baz

haha nothing like slating a bloke 4 years after the event

Wouldn't have taken him two seconds to have said thanks, but there we go...