Jump to content


damoyoung

Member Since 12 Oct 2007
Offline Last Active Dec 31 2007 04:11 PM
-----

Topics I've Started

How to empty a fruit machine!

12 November 2007 - 08:50 PM

I wonder how many views this thread will get...

Things Needed:

1x Tube of expanding foam
1x Rare earth magnet
2x Lock Pick Set
3x Swiss Army Knife with 'pick axe' attachment.

Can you see where this is going... i'm just biding time waiting for the wife and thought i'd write a little how-to!

Anyway,

1. Take expanding foam and fill speaker surrounds to inhibit pesky alarm sounds.

2. Take rare earth magnet, stick lower right hand side glass. Assuming pound coins are magnetic, (I haven't checked), pounds coins will be lifted from the hopper.

3. Remove the magnet. Assuming coins are above payout slide, you're in for a win.

4. If the above method doesn't work, take your lock pick set and have a go at the locks on the front of the machine; If successful, pop open the lid (front opening only!), stick your hand in the hopper and pull some coins.

5. Oh dear, magnet and lock pick set no good?

Take swiss army knife and whip out pick axe attachment; hit the glass panel in one corner. It may take a few swings, but the glass should break. Again, stick hand through broken glass, taking care not to cut yourself and whip out coins by the handful.

6. Assuming it has taken you less time than it takes for the owner of machine to pull bits of your anatomy off, run...

I haven't personally tried this out myself as I have none of the resources needed.

I also cannot be held responsible for any personal damages attained from attempting any of the methods I have described.

It beats feeding coins in machines and reading endless ebay manuals, that I am sure of!

Be sure to correct me where I may be wrong E&OE accepted.

Heh... I need to find something to do, quick :)

Scorpion 4 Flashing Reset Light?

05 November 2007 - 11:06 PM

Hello There,

Please! Could someone tell me why my the reset light on my scorpion 4 mainboard flashes constantly?

The machine is a Bell Fruit- Money to Burn.

When I power it up, the 4 power rail led's light on the mainboard, so I am assuming a working PSU.

Other than that, the machine plays dead, no lights, no reel spinning, just a little red reset led that flashes constantly.

I am in the process of looking for a workshop manual, but as of yet, no luck.

Any advice would be greatly appreciated!

Regards,

Damo.