Jump to content

  2. → Viewing Profile: Posts: scoobymark

scoobymark

Member Since 01 Jun 2008
Offline Last Active Jun 02 2008 06:49 PM
-----

Posts I've Made

In Topic: JPM Hi Impact machine help

02 June 2008 - 06:49 PM

I have taken out the game card, checked the pins and etc put it back in the slot but no different. There is a minor bit of corrosion on part of the game card but that doesnt appear to be a cause in my opinion.

When shorting the battery out, I assume it would be done in the same way as a car battery, bit of wire over the top? What does this do in fruit machine lingo?

I have found a new impact board for £9 so will fit that when it arrives. What happens if it is the game card are these easily found on the net?

Thanks guys, your help is much appreciated.

In Topic: JPM Hi Impact machine help

02 June 2008 - 07:18 AM

hi mark and welcome to fruit-emu

Can i get u to do a number of things for me please. One is to turn the machine off hold the impact test sw for 10/15 secons and turn the power back on just then let me know if the speaker pops. A number of time

Two would be to turn the machine off remove the processor card short the battery out. Or the cap close one to you looking at it was still fitted into machine

Once turn the machine on if after 20secons the status is not on then try resitting the programme proms.


Hi, thankyou for the information, it is much appreciated although I am very new to all of this so have a couple of Q's on your advice.

the processor card, this being the main board with the status light? do i need to remove it completely or can i just disconnect the loom from the battery/transformer?

secondly, how is the best method to short the battery, an again i assume this is the part where the power supply from house is plugged directly into?

when you say reset the programs proms, is this by again using the button on the processor board?

Sorry to be a pain just dont wanna do anything wrong....Nervous!!!

In Topic: JPM Hi Impact machine help

01 June 2008 - 10:26 PM

Any sign of the battery having leaked on the MPU?
It really is the number 1 killer of fruit machines.


The battery has no leakage at all and is in a very clean state, the machine has sat for a year although i cant see that being an issue as the location was no different to an average living room for climate etc...

  1. Fruit-Emu
  2. → Viewing Profile: Posts: scoobymark
  3. Privacy Policy
  4. Forum Rules ·