Jump to content

  2. → Viewing Profile: Posts: nellyuk

nellyuk

Member Since 28 Jul 2008
Offline Last Active Feb 27 2010 06:17 PM
-----

Posts I've Made

In Topic: test mode

14 February 2010 - 10:19 AM

Have you pressed both test buttons there should be a res square one on the mpu and a block round one just under the reels at the back.


Hi Tommy,

Yes, pressed both test buttons which dont do anything, just the same as releasing the door switch. Do you press and hold, both together or one at a time? Tried all the above anyway to no avail.:twitcy:

In Topic: test mode

13 February 2010 - 08:13 PM

ok if your on later or tomorrow bazpeeb will read your thread and he will know what to do to sort it for ya:).


Hi I have a Barcrest cash attack and have exactly the same prob. Can get cash details but no tests. I have the MPU5 manual but my machine doesn't follow the info in it. Will let you know if I find out anything!:err:

In Topic: Hey Check It Out error on Barcrest Cash Attack

08 February 2010 - 11:19 PM

Thanks, found the board in question on the top glass. Status light is flashing green and other LED is steady green. Remade all cons and checked fuses ok. Any other ideas, could the transport have damaged this board do you think or is it a wiring problem normally?


Just a quick update, I have tested all cabling and checked for dry joints, The status LED on the MXU is pulsing and the loan power transistor with heat sink is quite hot. If this lamp controller board is faulty does anyone know where I might seek a replacement please? It the 2002 MXU5E variant. Thanks.:undecided:

In Topic: Hey Check It Out error on Barcrest Cash Attack

07 February 2010 - 09:38 PM

the error is the lamp driver board


Thanks, found the board in question on the top glass. Status light is flashing green and other LED is steady green. Remade all cons and checked fuses ok. Any other ideas, could the transport have damaged this board do you think or is it a wiring problem normally?

In Topic: Hey Check It Out error on Barcrest Cash Attack

07 February 2010 - 08:59 PM

that error is mux unit missing


I'm think that the MUX unit is the reel driver and its def there and connected. As this machine has 3 reels plus a fourth in the top glass, could it be either of them which relate to this fault do you know? Thanks so much for the info.

  1. Fruit-Emu
  2. → Viewing Profile: Posts: nellyuk
  3. Privacy Policy
  4. Forum Rules ·