Jump to content


edandkel

Member Since 10 Mar 2009
Offline Last Active May 13 2011 05:38 AM
-----

Posts I've Made

In Topic: Fault On My Cops And Robbers Machine

24 March 2011 - 07:27 PM

The fault is that on the mother board scorpion 4 all green lights are lit but there is a red light constantly flashing, the machine will not light up or play at all

In Topic: Help with Problem Cops and Robbers £250 jackpot

26 October 2009 - 08:17 PM

seems like the gamecard my be knackerd


have u had this machine working at all ??


It was working fine before then all of a sudden packed up

In Topic: Help with Problem Cops and Robbers £250 jackpot

26 October 2009 - 07:50 PM

on the motherboard there should be a smaller board sticking out of it (on this machine I think it should be at the bottom )

with the machine off try and gently see if it will push in further then try the machine again



just noticed you said there are no other lights on the board ?

It could be a dead power pack but if there were no other lights I would suspect the reset light shouldnt be lighting up at all



see if there are any lights on the PSU which should be a silver box with holes in it in the bottom door


there are lights on the mother board 4 green lights that are lit and then the red reset light thats flashing I have tried again to push any loose connections back in but still no joy, also there is a light on the power supply

In Topic: Help with Problem Cops and Robbers £250 jackpot

26 October 2009 - 07:25 PM

my guess is that it is flashing because there is a problem that the machine cannot display on the alpha display itself .... usually its trying to tell you theres a problem stopping ht machine from starting up and its usually the gamecard not in properly or the gamecards faulty

not knowing much about friut machines where would I find the game card

In Topic: Help with Problem Cops and Robbers £250 jackpot

26 October 2009 - 07:12 PM

check nothings loose ( do this with the power off you dont want to short anything out or hurt yourself )


when i say loose i mean like cables to the motherboard, gamecard etc.


I tried that but still no Joy I don't understand why the red light (reset button) is constantly flashing any ideas